blast

…Measures include fencing and perimeter stand-off areas, land or maritime force patrols, lighting and sensors, vehicle barriers, blast protection, intrusion detection systems and electronic surveillance, and access control devices and systems. Physical security measures, like…

Chapter V V-58 JP 3-0 shielding against blast and radiation effects. Enhancement of CBRN defense capabilities may reduce incentives for a first strike by an enemy with WMD. (c) The combination of active and…

…A physical damage assessment is an estimate of the quantitative extent of physical damage (through munitions blast, fragmentation, or fire damage) to a target element based on observed or interpreted damage. Physical damage assessment is the…

…Commanders protect supply stocks against blast, shrapnel, incendiaries, and CBRN contamination using dispersion and constructing survivability positions. Forces can protect vehicles carrying supplies against almost anything but a direct hit by constructing berms large enough to…

…The APDS-T round penetrates urban targets by retaining its kinetic energy and blasting a small hole deep into the target. The APDS-T round gives the best effects behind the wall, and the armor-piercing…

…Normally, the blast will not collapse a properly constructed bunker, but it can cause structural damage. The 60-mm mortar will not normally create craters in a hard-surfaced road. (2) 81-mm Mortar. The 81…

…The M34 can be combined with flammable liquids, detonating cords, blasting caps, and fuze igniters to create the eagle fireball, a field-expedient antiarmor device. (See FM 21-75, Combat Skills of the Soldier, Appendix H…

…It can be used for light blasting and demolitions and for creating breach holes in interior walls. The concussion produced by the MK3A2 is much greater than that of the fragmentation grenade. It is very effective…

…be made by punching or drilling holes in walls and should be placed where they are concealed. Blasting loopholes can result in a large hole that can easily be seen by the enemy. (b) Loopholes should…

…Examples of non-immediate DOD EOD support include, but are not limited to, post-blast analysis, use of DOD material and equipment, and support of preplanned events. (5) DOD EOD forces providing support under immediate response…

…Because of the design of the warhead and the narrow blast effect, these weapons are not as effective in this role as heavier weapons such as a tank main gun round. Their light weight allows Marines…

…Loose items were not hurled around the room. (b) No substantial degradation occurs to the operator’s tracking performance as a result of obscuration or blast overpressure. (c) The most serious hazard that can be expected…

…Secondary tasks may involve blasting holes in structures and fortified positions. As with other weapons systems, antiarmor weapons are normally employed in a decentralized fashion at the small unit level. Enemy armor should be engaged in…

…Backblast Areas of Light Recoilless Weapons in the Open (1) When firing recoilless weapons in the open, Marines should protect themselves from blast and burn injuries caused by the backblast. All personnel should be out of…

…Also, gases found in sewers can be ignited by the blast effects of these munitions. For these reasons, small-arms weapons should be employed in tunnels and sewers. Friendly personnel should be outside of tunnels or…

…Another way to enter a room is to blast mouseholes with demolitions. In moving from room to room through mouseholes, Marines should use grenades to clear the room as they do in moving through open doorways…

…Another way to enter a room is to blast mouseholes with demolitions. In moving from room to room through mouseholes, Marines should use grenades to clear the room as they do in moving through open doorways…

…prone position, his/her lower body must be perpendicular to the bore of the weapon, or the blast could cause injury to his/her legs. Figure B-5. Firing an AT4 From Inside a Building c…

…Reinforce fighting positions with sandbags or other fragment- and blast-absorbent material. (4) Maintain the natural look of the area. (5) Keep positions hidden by clearing away minimal debris for fields of fire. (6) Choose firing…

…Keep the blasting machine under the control of a noncommissioned officer. Wear helmets and flack jackets at all times while firing explosives. Handle misfires with extreme care. Clear the room and protect personnel when blowing interior…